Entec EVRC2A-N6-NT - Page 5

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
iii
ENHANCED TECHNOLOGY
- Change “RECORDER” in “1.2. Summary of Features”.
- Add “Power Quality” in “2.5. Monitoring”.
- Change “SYSTEM EVENT RECORDER”, “POWER QUALITY EVENT RECORDER”,
“COUNTER” in “2.6. Recorder”.
- Change “Figure 3-12. Menu Structure Tree” in “3.2.1. Main Menu Summary”.
- Add settings for Unbalance in “6.10. Power Quality”.
- Add Unbalance Counter in “11.4. Power Quality”.
- Change “12.2. System Event Recorder”.
- Change “12.6. Power Quality Event Recorder”.
3. Section to be rectified in the manual as a result of adding “Daily Max I” and “Daily Energy”
settings.
- Change “5.2.5. EVENT&ETC”.
4. Section to be rectified in the manual as a result of changed range of reclose interval 1.
- Change “Reclose interval 1” in “2.4. Protection Elements/ Reclose Control”.
- Change “Range of Reclose 1” in “7.1. Reclose(79)”.
[Aug. 2012] Ver7.00
Changed the manual based on EVRC2A_N6 firmware V6.15 upgrading.
1. Change “5.3. Clock”.
2. Change “5.8. Time Set & Display Type”.
- Add “Set Type”, “GMT Sign”, “GMT Hour”, “GMT Min” and “Evt Send Type” set-up in
“RELAY SETUP/ TIME SET & DIS TYPE” menu.
3. Change “SEF Pickup Current Setup” in “7.4. Sensitive Earth Fault (SEF)”.
4. Change “9.3. Clock”.
5. Change “10.1.4. Synchro Voltage”.
6. Change “Table 14-1. Warning Events” in “14.1. Warning Events”.
[Nov. 2012] Ver7.10
1. Changed the manual based on EVRC2A_NT firmware V7.04 upgrading.
- Change “5.2.2.1. DNP 3.0 Protocol – Option” : Add “Time Req(m)” set-up in
“COMMUNICATION / PROTOCOL SETUP / DNP1 and DNP2” menu.
- Change “5.2.3.1. PORT2-RS232” : Add “Parity Bit”, “Data Bit” and “Stop Bit” set-up in
“COMMUNICATION/ PORT SETUP/ PORT1-RS232” menu.
- Change “5.2.5. EVENT&ETC” : Add “Time Syn’ Ref” and “Evt Time Type” set-up in
“COMMUNICATION/ EVENT&ETC” menu.
- Change “5.8. Time Set & Display Type – Option” : Add “Time Syn’ Ref” set-up in “RELAY