Entec EVRC2A-N6-NT - Page 70

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
60
ENHANCED TECHNOLOGY
COMMUNICATION/ PORT SETUP/ PORT2-RS232/ CTS Chk Out
Range
1 ~ 255 sec
Default
5
Step
1 sec
Set a waiting time that waits CTS signal after RTS signal is ON. In case
of radio communication system, when transfer data at the same time
from various Slave, it produces transmission permission delay time due
to the wireless network traffic congestion. By this setting, try the
transmission with high RTS during checkout time.
It is available if ‘CTS Function’ setting is ON.
COMMUNICATION/ PORT SETUP/ PORT2-RS232/ DCD Timeout
Range
0 ~ 60000 msec
Default
5000
Step
1 msec
Set a delay time for checking DCD signal which determines modem
status before sending RTS signal in 2-wire communication type. If
DCD signal is ON, EVRC2A does not transfer the data and treat it as
DCD Fail after the set time. It is available if ‘DCD Function’ setting is
ON.
COMMUNICATION/ PORT SETUP/ PORT2-RS232/ TX Post Delay
Range
0 ~ 60000 msec
Default
50
Step
1 msec
Set the delay time of RTS OFF after data transmission.
COMMUNICATION/ PORT SETUP/ PORT2-RS232/ TX Pre Delay
Range
0 ~ 60000 msec
Default
5
Step
1 msec
Set the delay time of starting transmission after CTS signal is received.
[PORT1-RS232]
>DCD Timeout: 5000
>TX Post Dly: 50
>TX Pre Dly: 50
[PROT1-RS232]
>CTS CheckOut: 5
>DCD Timeout: 5000
>TX Post Dly: 50
[PORT1-RS232]
>CTS Chk Out: 5
>DCD Timeout: 5000
>TX Post Dly: 50
[PORT1-RS232]
>CTS Chk Out: 5
>DCD Timeout: 5000
>TX Post Dly: 50