Entec EVRC2A-N6-NT - Page 71

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
61
ENHANCED TECHNOLOGY
5.2.3.2. PORT3-RS232/485
EVRC2A side panel PORT3 and related elements are set.
Move to “PRIMARY, ALTERNATE or EDITBANK SETTING/ COMMUNICATION/ PORT
SETUP/ POR3-232/485” to select setting for PORT3.
The setting item of this menu is same as “PORT2-RS232”. Refer to “5.2.3.1. PORT2-RS232”.
5.2.3.3. PORT4-TCP/IP
EVRC2A side panel PORT4 and related elements are set.
Move to “PRIMARY, ALTERNATE or EDITBANK SETTING/ COMMUNICATION/ PORT
SETUP/ POR4-TCP/IP” to select setting for PORT4.
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / IP Addr’1 ~ 4
Range
0 ~ 255
Default
~
Step
1
Select the IP Address for EVRC2A.
IP Address : 192
.xxx.xxx.xxx
① ② ③ ④
IP Addr´1,2,3,4 is ①,②,③,④
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / Gateway Addr’1 ~ 4
Range
0 ~ 255
Default
~
Step
1
Select the Gateway Address.
Gateway Address : 192
.xxx.xxx.xxx
① ② ③ ④
Gateway Addr´1,2,3,4 is ①,②,③,④
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / SubnetMask
Range
255.0.0.0 ~ 255.255.255.255
Default
255.255.255.000
Step
1
Select the Subnet Mask Address for EVRC2A.
[PORT4-TCP/IP]
>Gateway Oct3: 0
>Gateway Oct4: 0
>S/M:255.255.255.000
[PORT4-TCP/IP]
>Gateway Addr’1: 0
Gateway Addr’2: 0
Gateway Addr’3: 0
>Gateway Addr’4: 0
[PORT4-TCP/IP]
>IP Addr’1: 0
IP Addr’2: 0
IP Addr’3: 0
>IP Addr’4: 0