Entec EVRC2A-N6-NT - Page 72

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
62
ENHANCED TECHNOLOGY
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP /K- Alv’ Function
Range
DISABLE, ENABLE
Default
DISABLE
Step
~
Select whether to use the Ethernet communication connecting status
check function or not.
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / K-Alv’ Idle T
Range
1 ~ 255 sec
Default
4
Step
1sec
If Idle status is maintained during the setting time, check the
communication connecting maintainance status.
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / K-Alv’ Interval
Range
1 ~ 255 sec
Default
2
Step
1sec
After checking the communication connecting status, check the status
again if there isn’t any reply during the setting time.
COMMUNICATION/ PORT SETUP/ PORT4-TCP/IP / K-Alv’ Retry
Range
1 ~ 255
Default
1
Step
1
Check the communication connecting maintainance status as much as
the setting number. If there isn’t a respond, take as communication fail
and close the communication connection.
[PORT4-TCP/IP]
>K-Alv’ Idle T: 4
>K-Alv’ Interval: 2
>K-Alv’ Retry: 1
[PORT4-TCP/IP]
>K-Alv’ Func:DISABLE
>K-Alv’ Idle T: 4
>K-Alv’ Interval: 2
[PORT4-TCP/IP]
>K-Alv’ Func:DISABLE
>K-Alv’ Idle T: 4
>K-Alv’ Interval: 2
[PORT4-TCP/IP]
>K-Alv’ Func:DISABLE
>K-Alv’ Idle T: 4
>K-Alv’ Interval: 2