Installation
Eppendorf Xplorer
®
/Eppendorf Xplorer
®
plus
English (EN)
23
Procedure for recharging the rechargeable battery
1. Insert the assembled power supply unit into a socket.
2. In the Xplorer pipette check whether a rechargeable battery is inserted and connected.
3. Insert the charging plug of the power supply into the connector socket of the pipette.
The display briefly shows the connection with the power supply. The charging process
is indicated in the display by a flashing rechargeable battery symbol. If the
rechargeable battery is almost completely discharged, the display will only switch on
after a slight delay.
4. Switch on the pipette to observe the charging process.
5. Charge the rechargeable battery for at least three hours.
The rechargeable battery will only achieve its full capacity after several discharge/
charge cycles.
For storing and charging the single-channel and multi-channel Xplorer pipettes, you can
alternatively use a series 4880 charger stand or charger carousel.
Charger stand 4880 4880 charging carousel
To Next Page
Loading...
