Operation
Eppendorf Xplorer
®
/Eppendorf Xplorer
®
plus
English (EN)
51
5.17.3 Creating or changing Program
Creating a new program
1. Select the New program entry using the rocker. Up to 10 programs can be saved.
You will be prompted to name the program. You can enter a name with a maximum of
six characters.
2. Select the characters using the rocker.
3. Press the Next softkey to switch to the next field.
4. Press the Save softkey to save the name.
5. Select the first operating mode. All operating modes except Manual Pipetting are
available.
6. Press the Edit softkey.
7. Change the parameters of the mode as usual.
8. Press the Save softkey.
A list with all of the previously saved program modes appears.
• Press the Next softkey to add another mode. A program can contain up to 4 modes.
• Press the Save softkey to save the program. The saved program now appears in the
Program (Prg) operating mode.
Changing the saved program
Prerequisites
To change the mode of a program, the program needs to be saved first.
1. Select a saved program from the list.
2. Press the Select softkey.
3. Select the Edit option.
4. Press the Select softkey.
• Select the Edit mode option to change a program mode.
• Select the Insert mode option to add a mode to the program.
• Select the Delete mode option to delete a program mode.
The program name cannot be changed later. Copy the program to change the
name. You will be prompted to enter a new name. Then delete the original
program.
Select the Copy option to create a program based on another program. You must
then enter a name for the copied program. If you only want to change the name
of a program, select the Copy option.
To Next Page
Loading...
