Operation
Eppendorf Xplorer
®
/Eppendorf Xplorer
®
plus
English (EN)
55
5.19.3 Counter – switching the counter for dispensing steps on/off
The counter provides information on the dispensing operations performed in the Pip
mode. You can switch the counter on and off using the rocker. After you select the Pip
mode, an activated counter shows 0. The value can be changed in the Pip mode.
5.19.4 Ejector reset labware
The Ejector reset option has two settings:
• ON (default setting) – the piston automatically moves to the basic position even when a
filled pipette tip is ejected.
• OFF – the piston does not automatically move to the basic position.
5.19.5 Rocker setting – setting the speed of the rocker
The change speed of the volume in the editing mode can be adjusted to suit your needs. 8
levels are available (1 = slow, 8 = very fast). Level 5 is set upon delivery.
5.19.6 History – saving and displaying dispensing settings
If you activate the History option, the History softkey will be activated instead of the Help
softkey for most of the operating modes. The last 10 dispensing settings of the active
mode can be accessed using the History softkey. The dispensing steps appear in
chronological order. Dispensing settings will only be stored if the History option is
activated.
5.19.7 Setting the Sound level
You can change the sound volume of the acoustic signals. At 0 volume, the sound is
switched off and the symbol will not be displayed.
5.19.8 Setting the Brightness (display)
The display brightness can be adjusted to suit your needs.
CAUTION! Unintended dispensing when the Ejector reset option is activated.
When working with a removed ejector sleeve, set the Ejector reset option to
OFF to prevent unintentional dispensing from the pipette tip in case the
ejector is accidentally pressed.
To Next Page
Loading...
