Eppendorf Xplorer - Charging the rechargeable battery

22
Installation
Eppendorf Xplorer
®
/Eppendorf Xplorer
®
plus
English (EN)
4.3 Charging the rechargeable battery
2. Connect the plug of the rechargeable
lithium polymer battery to the connector
socket.
3. Close the rechargeable battery
compartment cover.
On the Xplorer plus pipette, you will then
be prompted to set the date and time
(see p. 24).
WARNING! Incorrect or damaged mains/power supply devices may lead to
severe personal injuries and damage to the device.
Incorrect or damaged mains/power supply devices may cause electric shock,
overheat the device, set it to fire, melt it, short-circuit it or cause similar damage.
 Only the supplied mains/power supply device may be used to charge the
device. You can identify the correct mains/power supply device by the
Eppendorf logo and the device name on the mains/power supply device.
 Do not use damaged mains/power supply devices.
NOTICE! Loss of full battery charging capacity of the rechargeable battery if
charged incorrectly.
The supplied rechargeable battery is not fully charged. The rechargeable battery
will reach its full capacity only after several discharging and charging cycles.
 Do not charge the rechargeable battery in a hot environment (> 60°C).
 Only charge the rechargeable battery using the supplied mains/power supply
device.
For identification purposes, the power supply contains a sticker with the name of
the compatible devices. The power supply is designed for the 100 V – 240 V
range.
Multipette
®
stream / Xstream
Repeater
®
stream / Xstream
Xplorer
®
Xplorer
®
plus
Easypet
®
3 4986 603.005