Epson C8-B - Page 33

C8-B/C12-B Service Manual Maintenance Information Disclosure Scope: Maintenance Trained Personnel Only
(C) Seiko Epson Corporation 1-27 Rev.1
If any swelling, damage or deterioration is observed in the O-ring, replace the O-ring using
the following procedure.
1. Lightly coat the O-ring with grease (SK-2).
2. Install the O-ring in the groove in the base.
POINT
Make sure the O-ring does not protrude from the groove.
Install the Arm #5 grease inlet cover.
3
O-ring
4
A
S01: 4-M3x6
（2.0 +/- 0.1 N·m）