SC-F2000 Revision C
ADJUSTMENT TF Adjustments 261
Confidential
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
4.13.5 TF Position Detection Sensor Check
EXECUTION MODE
Normal Mode
PROCEDURE
1. Turn the printer ON.
2. Start the Service Program and select [TF position detection sensor Check].
3. Click [RUN] to move the Table Assy.
Figure 4-63. [TF position detection sensor Check] Screen
4. The following screen is displayed when the Rear TF Sensor detects the Table Assy
correctly.
Figure 4-64. Result (Rear TF Sensor)
5. Press [OK] to move the TABLE ASSY to the front of the printer again.
6. The following screen is displayed when the Front TF Sensor detects the Table
Assy correctly.
Figure 4-65. Result (Rear TF Sensor)
7. Click [OK] to finish the adjustment.
To Next Page
Loading...
