Page 17 of 159
3 Installation
Your Erba Lachema certified service engineer will perform the initial installation of the ‘ELite
5’ analyzer and train you and selected laboratory personnel on the proper use and
maintenance of the analyzer. The analyzer should only be operated by properly trained
personnel. You’ll also be explained about necessary maintenance actions.
3.1 Package contents
3.1.1 The ‘ELite 5’ Analyzer Package
After opening the ‘ELite 5’ analyzer packaging, you will find an accessory box. The analyzer
is in a plastic bag in between cushioning protective material. After opening the bag, remove
the desiccant packs. The package should contain the following items:
• ‘ELite 5’ analyzer
• Accessories box on top of the analyzer, containing:
• Power cord
• User Manual (this document)
• Sample tube adapter for the individual sample unit (1 pc)
• Reagent tube kit (in a plastic bag, with special caps)
• Plastic waste container
• Cardboard box for the waste container
• “Preparing for shipment” tube kit
• ‘ELite 5’ analyzer Final Check Report
Please inform your Sales Representative if any item is missing or damaged. Retain the
original ‘ELite 5’ analyzer packaging for future transportation and storage.
3.1.2 The Autosampler Package
The Autosampler is an optional unit that attaches to the ELite 5. If the optional Autosampler
unit was ordered, package should contain the following items:
• Autosampler unit
• Sample tray
• Sample racks -10 pieces
• Autosampler Final Check Report
Please inform your sales representative if any item is missing or damaged. Retain the
original Autosampler packaging for future transportation and storage.
3.1.3 Small Sample Package (optional)
• SSM Micro dilutor front-left frame rail assembly
• Ribbon cable #1 with connectors for the SSM micro dilutor
• SSM valve assembly with connected Tygon tubing
• “T” fitting with attached 3 cm Tygon tube
• 4-way ribbon cable #2 with connectors for the SSM valve assembly
• Pre-dilution chamber plus pre-dilution chamber holder assembly with rubber chamber
protector
• SSM sample rotor plate
• 2 pcs of 3x10 hex screws with washers (used for mounting SSM pre-dilution chamber holder)
• Adhesive cable holder, plastic adhesive tube holder and 2 pcs of plastic tube holders
To Next Page
Loading...
