Page 39 of 159
• Initiate a primary blank measurement
• Make adjustments and settings about the manual measurement:
o Enter the Sample ID (unique or auto-increment)
o Select the associated patient
o Select the sample type or patient mode
• Start a manual measurement
• View the measurements results in detail:
o View the measured parameters
o View the calculated parameters
o View parameters that are out of the normal range
o View error, warning, or clinical flags
See section 7.4.1 for more information about manual measurements.
5.7.3 Start Automated Measurements
Tapping or clicking the ‘AS’ icon with the multiple sample tube graphic allows access to the
following functions:
• Initiate automated measurements in one of three run modes:
o Full scan mode
o Free list mode
o Selected samples mode
o Remote worklist mode
• Define sample parameters (the parameter list depends which one of the three sample
modes is selected)
• Monitor the progress of the automated measurements
• View the details of completed measurements
See section 7.4.3 for more details about the automated measurements.
5.7.4 Access the Database
Tapping or clicking the ‘Database’ icon with the file cabinet graphic allows access to the
following functions:
• Select completed and measurement stored as database records
• Export database records for storage or import results for viewing
• Delete database records
• Send database records to the LIS
• Review the details of selected measurements
See section 9 for more details about accessing and using the ‘ELite 5’ database.
5.7.5 Initiate Printing
Tapping or clicking the ‘Print’ icon with the printer graphic will print the active panel or
measurement result according to the printer settings.
See section 13.6 for more details about printing on the ‘ELite 5’ analyzer.
To Next Page
Loading...