Alternatively, the table entries can be edited by browsing to Device Configuration >
Advanced Setup > Base Unit > BISS keys table and selecting the required key
location.
Figure 3.58 BISS Key Session Word
To set up BISS encryption service from the GUI:
1. Go to the Outputs widget of the Service Configuration page, and select the
service for which you want to apply BISS encryption.
2. In the Properties tab select the drop down option against BISS Key, which will
show the list of 31 keys. Select the required key location.
Note: If None is selected, BISS will not be enabled.
To Next Page
Loading...
