settings as you did on the AVP 4000 unit, otherwise the embedded information
will not reflect the structure of the internally created Transport Stream.
Figure 3.31 Setting External PSIP Data Insertion on the GUI
3.7.14 How to Configure PSIP Pass-thru
When using an EI9001T card for a transcoding operation, the user can pass-thru a
range of PIDs that allow the pass-thru of PSIP tables. Two groups of PID ranges as
well as individual PID values can be entered by the user.
To configure PSIP Pass-thru:
1. Drag-and-drop the incoming Service from the pre-configured input TS (see
Section 3.7.10).
To Next Page
Loading...
