Ericsson AVP 4000 - CE Option Modules; Digital Video Input (CE-HEVC;BNC Option Module)

Installing the Equipment
2-6
1/1553-FGC 101 1790 Uen Y
Table 2.5 Port Status: Left (Green ) LED
Port
Status
Link Speed LED Status
Active
Port
No Link Off
— — — — — — — — — — — — — — — — — —
100 Mbps Flash Off x 2
— ☐ — ☐ ☐ ☐ ☐ ☐ ☐ — ☐ — ☐ ☐ ☐ ☐ ☐ ☐ ☐
1000 Mbps Flash Off x 3
— ☐ — ☐ — ☐ ☐ ☐ ☐ — ☐ — ☐ — ☐ ☐ ☐ ☐ ☐
Spare
Port
No Link Off
— — — — — — — — — — — — — — — — — —
100 Mbps Flash On x 2
☐ — ☐ — — — — — — ☐ — ☐ — — — — — —
1000 Mbps Flash On x 3
☐ — ☐ — ☐ — — — — ☐ — ☐ — ☐ — — — —
The left LED flash sequence period is 1 s, with a short flash duration of 100 ms.
Table 2.6 Link Activity: Right (Yellow ) LED
Link Speed LED Status
No Link Off
— — — — — — — — — — — — — — — — — —
Link On
☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐ ☐
Activity Flash
— ☐ — ☐ — ☐ ☐ ☐ ☐ ☐ — ☐ ☐ ☐ — ☐ ☐ ☐
2.3.4 CE Option Modules
The following connectors are provided on the CE Video Compression Modules.
2.3.4.1 Digital Video Input (CE-HEVC/BNC Option Module)
High definition digital video can be input via the four 75 Ω
female BNC connector (labeled SDI 1-4) on the rear
panel.
For HD video, each connector is the video source for
channels 1-4. Ultra High Definition (UHD) (4K) video
encoding uses all four SDI BNC connectors. The input
video maybe either formatted as 4 synchronized HD
quadrants or as 4 synchronized interleaved (SMPTE-425-
5) sub pictures.
The LED (labeled LOCK) next to each connector shows
the lock status of the input video signal for that connector.
In encoding more than one channel of H264 or HEVC video the relevant multi-
channel license (x4) needs to be purchased. If only one channel is licensed, the first
connector (labeled SD 1) must be used for video input. The other connectors will not
be operational unless in UHD.