6.5.2.4 Timing
The VCM aligns the VBI data and the compressed video frames, i.e. it uses the
same PTS for the video and the VBI data if they are from the same frame.
6.6 Logo and Full Slate
6.6.1 Logo Insertion on AVP 4000
The AVP 4000 supports the insertion of one on screen logo per video input. The
logo is uploaded from the web interface.
6.6.1.1 Logo Format
The logo format supported is OSD type 6. A bitmap image can be converted offline
using the logo utility that converts the logo from bitmap format into OSD format. The
encoder supports logo for a full resolution screen; however, there is a limit for
storing the OSD6 logo file and the limit is 2 Mbyte.
6.6.1.2 Logo Upload
It is recommended to first configure the video services and then upload the logo file.
The logo can be uploaded from the web interface as follows:
1. Navigate to the Input tab of the Video component.
2. Navigate to the location of the Logo file (for example logo.osd) and press the
Upload button.
Figure 6.7 Uploading the Logo File
To Next Page
Loading...
