Telephone Number Enables entry/editing of a telephone number.
Telephone Extension Enables entry/editing of a telephone number.
Latitude Enables selection of latitude.
Longitude Enables selection of longitude.
User Information Enables entry of user information.
NIT Descriptor Tag Enables entry/editing of a NIT descriptor tag.
USB Control
1
Format USB Stick Recreates the default directory structure on the USB stick connected to the front panel.
1 Visible only when a USB drive is detected.
4.4.2 Advanced Menu
The Advanced menu allows access to all of the Advanced menus for the installed
option cards. Selecting the option card (the parameters of which you wish to edit)
from the Slot <n> option will give access to the required menu.
If no option card is selected, the System menu is displayed as shown below.
Table 4.8 Advanced Menu
Advanced
Slot <n> See the menu of the installed card:
EI9001 Encoder / EI9001T Transcoder Advanced Menu
External Sync Input Card
ASI Option Card Advanced Menu
System
Network Configuration
Check Duplicate IP Address
Enable, Disable. If enabled, the unit checks whether there is another unit with the same
IP address within the network by sending out ARP messages.
Control Interface Group
Network Mode
Same-Network, Different-Network. Read only parameter for the control interface, and is
set to Same-Network.
IP Redundancy Mode
Active-Active, Active-Standby. Describes how the spare interfaces will behave. For the
control port, it is set to Active-Standby and is read only.
Autorevert
Auto-revert to Primary, Auto-revert to Secondary. Shown only if the IP Redundancy
mode is set to Active-Standby. Determines what to do when connection is lost.
Autorevert Delay
The delay in seconds before automatic redundancy switching takes place. Shown only if
the IP Redundancy mode is set to Active-Standby.
Active Interface
Read only parameter. Displays which interface is active. In Active -Active redundancy
mode both interfaces are active.
Line Speed Auto, 100 Mbps, 1 Gbps. The transmission speed of the link.
Duplex Mode
Auto, Full Duplex, Half Duplex. Determines whether data should be transmitted and
To Next Page
Loading...
