EasyManua.ls Logo

Ericsson AVP 4000 - How to Configure the Front Panel Video Confidence Monitor; How to Configure VLAN Tagging

Ericsson AVP 4000
422 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Getting Started
3-52
1/1553-FGC 101 1790 Uen Y
4. Set in the intended quality in the Target Quality field. Currently, this value is not
observed by the video encoding module, and it is for future purposes only.
3.7.19 How to Configure the Front Panel Video Confidence Monitor
The confidence monitor on the front panel can be configured to monitor the video
input on any VCM fitted to the chassis, from either the GUI or the front panel.
To configure the confidence monitor, proceed as follows:
1. From the GUI go to
Device Configuration > Advanced Setup > Base Unit >
Front Panel Parameters > Video Monitor Setup > Video Monitor Video Select
.
The Properties panel will provide a drop down box listing all available sources with
the relevant slot number (in many cases this will be only a single VCM).
2. Select the required source.
There is a preview time for the confidence monitor that sets the time the monitor
display is active from the time the On button is pressed. This is to help maximize the
life of the monitor. If a longer preview time is required, proceed as follows:
1. From the GUI go to Device Configuration > Advanced Setup > Base Unit >
Front Panel Parameters and set the Video Monitor Preview Time to the
required value (in seconds).
2. From the front panel navigate to Unit Config > Display Setup > Video Monitor
Input and select the required source.
3.7.20 How to Configure VLAN Tagging
VLAN tagging can be used to segregate IP packets from data interfaces.
VLAN Creation
A VLAN is created by specifying the VLAN ID, IP address and the Netmask. All
Transport Streams which are tagged to this VLAN use the VLAN IP address as its
source IP address. Hence the VLAN and VLAN ID must be created before it can be
used to tag a Transport Stream.
To create VLANs, navigate to Device Configuration > Advanced Setup >
Encoder > Vlan Tags and select the output you want to assign the VLAN tag to,
and click Add in the Properties pane. Alternatively, on the front panel navigate to
Advanced/System/Vlan Tags and set up the VLANs as required. The available
options are listed in the following table.

Table of Contents

Related product manuals