Ericsson AVP 4000 - Adding a Service to a Transport Stream; Adding a Transport Stream to an Output; Using the Service Configuration Page

Web GUI Control
1/1553-FGC 101 1790 Uen Y
5-27
5.5.2 Using the Service Configuration Page
This section describes the tasks that can be completed on the Service Configuration
page.
5.5.2.1 Adding a Transport Stream to an Output
To add a Transport Stream to an output, do the following:
1. In the Outputs widget, select the output you want to add a Transport Stream to.
2. Right click on the selected output.
3. Select Add Transport Stream from the context menu.
OR
1. In the Outputs widget, select the output you want to add a Transport Stream to.
2. Click Action > Add Transport Stream.
OR
1. In the Outputs widget, select the output you want to add a Transport Stream to.
2. Right click on the selected output and choose Add Transport Stream from the
context menu.
Note: Outputs other than the IP outputs cannot have more Transport Streams
associated to them.
5.5.2.2 Adding a Service to a Transport Stream
To add a service to a Transport Stream, do the following:
1. In the Outputs widget, select the Transport Stream you want to add a service to.
2. Right click on the selected Transport Stream.
3. Select Add Service from the context menu.
OR
1. In the Outputs widget, select the Transport Stream you want to add a service to.
2. Click Action > Add Service.
OR
1. In the Outputs widget, select the Transport Stream you want to add a service to.
2. Right click on the selected Transport Stream, and choose Add Service from the
context menu.