5.4.4 Configuring Option Cards Using the Device Configuration Page
This section gives the tables of parameters available for configuring the option cards
using the Device Configuration Web Page.
5.4.4.1 ASI Option Card
The ASI Option module provides ASI outputs for the transmission of MPEG-2
Transport Streams. When an ASI option module is fitted in a base chassis, the host
detects its presence and adds the option to configure a Transport Stream to be
output over ASI.
5.4.4.1.1 ASI Output Configuration
The following parameters are available through the Advanced Setup tab of the
Device Configuration page under Slots > Slot <n> - ASI IO Option Card > ASI IO
Option Card > ASI Output Streams. The same parameters can be accessed
through the Advanced/ASI/ASI Output Streams menu on the front panel.
Table 5.3 ASI Output Configuration Parameters
Parameter Values Description
Output Mode Mirrored, Independent
Specifies whether the two outputs output the same
Transport Stream or they operate independently. If set to
Mirrored, only one output will be accessible.
5.4.4.2 External Sync Input Option Card
The External Sync Input Option Card has no configurable parameters. To configure
the external sync input to be used as the clock source, from the web interface,
browse to Device Configuration > Advanced Setup and under Base Unit set the
MUX SCR Source to External. Alternatively, on the front panel use the External
option under Advanced/System/Base Unit/MUX SCR Source.
5.4.4.3 EI9001(T) Option Card
It is recommended that the configuration of the EI9001 and EI9001T cards is done
through the Service Configuration Page.
5.4.5 Configuring Base Unit LDAP User Authentication
This section describes the options for Lightweight Directory Access Protocol (LDAP)
that can be used to authenticate a user before full access is granted to the AVP via
the Web GUI through the parameters available via the page Device Configuration
> Advanced Setup > Base Unit > Remote Authentication and HTTP server
options.
To Next Page
Loading...
