Ericsson AVP 4000 - ASI I;O Option Card Connectors; External Sync Input Option Card Connector

Installing the Equipment
2-8
1/1553-FGC 101 1790 Uen Y
2.3.5 ASI I/O Option Card Connectors
The ASI I/O Option Card rear panel provides two ASI inputs and two ASI outputs.
Figure 2.2 ASI I/O Option Card
Table 2.9 ASI I/O Option Card Connectors
Item Specification
Connector types 75 Ω female BNC
Connector designation ASI IN 1
ASI IN 2
ASI OUT 1
ASI OUT 2
Pin-outs Centre
Shield
Input
Ground/Chassis
The input connectors are used for feeding the unit with external Transport Streams
for external data insertion.
The output connectors can be configured as a mirrored output pair (with the same
Transport Stream on both outputs) or two independent outputs (with different
Transport Streams on each output).
2.3.6 External Sync Input Option Card Connector
The External Sync Option Card rear panel connector is used for connecting a
10 MHz 1 V
pp
reference signal or an analogue video signal.
Figure 2.3 External Sync Input Option Card
Table 2.10 External Sync Input Option Card Connector
Item Specification
Connector types 75 Ω female BNC
Connector designation SYNC IN
Pin-outs Centre
Shield
Input
Ground/Chassis