Export All Configurations Exports all the configurations stored on the unit to a USB stick.
Select Configurations to
Export
Export Selected
Configurations
Exports the selected configurations and stores them on the USB stick attached to the front panel.
Device Config <n>:
<name>
The list of configurations stored on the USB stick. The configurations to be exported can be selected
by pressing the Select button on the keypad.
Device Config <n>: <name> Exports one particular configuration to USB stick.
1 Visible only when a USB drive is detected.
4.4.1.2 A/V Encoder Menu
The A/V Encoder Menu displays the VCM specific audio/video encoder settings. The
menu options are shown in Table 4.5.
Table 4.5 A/V Encoder Menu
A/V Encoder
Video Input Locked
Yes, No. Read only parameter. Indicates whether a video lock is achieved for the SDI streams. For internal
streams, its value is always Yes.
Video Bit Rate Bit Rate of the video component encoded by the encoder card.
Video Profile The video profile and level to use for encoding the source.
Buffer Mode CBR, Seamless, Fast Channel Zap, Capped VBR..
Source SDI, Bars, Black, Moving Object, Slate
1
. External SDI source or internal source to be encoded.
Audio Monitor
Displays the levels for the channels associated with audio modules on the VCM card. To select between the
audio modules, turn the rotary knob.
Audio Module <n> For a full list of the menu items in the Audio Module <n> menu.
4.4.1.3 Output Menu
The Output Menu is used for building a Transport Stream on a specific output. The
menu options are shown in Table 4.6.
Table 4.6 Output Menu
Output
IP Output <n> The IP output is either a physical interface or a bond of physical interfaces.
Data Interface Group <m> Selects interface group <m> to modify its parameters.
Network Mode
Same-Network, Different-Network. If set to Different-Network, the
two ports in the group can belong to different subnets. In Different-
Network mode only the Active-Active Redundancy mode is
supported.
IP Redundancy Mode
Active-Active, Active-Standby. Describes the behavior of the spare
interfaces. Currently, data output pairs that make up the data
interface group are mirrored outputs.
To Next Page
Loading...
