- aag, aah for fourth dual mono
• Second instance on Audio Module 2:
- bba, bbb for first dual mono
- bbc, bbd for second dual mono
- bbe, bbf for third dual mono
- bbg, bbh for fourth dual mono
When adding PAA to an output Transport Stream service, each audio component
that makes up the PAA must be manually added to the service before configuring
the components for PAA.
3.7.30.2 Configuring Phase Aligned Audio
To set up PAA, or dual PAA, audio streams for a service on the Service
Configuration page, proceed as follows:
Note: This procedure assumes that a service has already been created. If not, one
must be created before continuing. See section 3.7.5.
1. In the Inputs widget, select Audio 1- Audio 3 (for 6 channel aligned) or Audio 1
- Audio 4 (for 8 channel aligned) by first selecting Audio 1, holding down the
Shift key, then clicking on Audio 3 (for 6 channel aligned) or Audio 4 (for 8
channel aligned).
2. Drag the selected components to a service in the Outputs widget.
Figure 3.69 PAA - Adding Audio Components
3. In the Outputs widget, click on the audio component corresponding to Audio 1.
To Next Page
Loading...
