Note: If you click on Audio Stream 1 in the Inputs widget, the corresponding
audio stream will be highlighted in grey in the Outputs widget.
4. In the Properties widget, click on the Input tab, and set the Input Format to
Uncompressed LPCM.
5. Set the Input Source to Embedded 1 (SDI 1).
Figure 3.70 PAA - Setting Input Sources
6. Click on the Encode tab and set the Coding Standard to MPEG Layer II.
Figure 3.71 PAA - Setting Coding Mode
The other components of the same group will be automatically configured.
7. If you are setting up dual PAA encoding, repeat steps 1-4 for Audio 9 - Audio
11 (for 6 channel aligned) or Audio 9 - Audio 12 (for 8 channel aligned).
8. If dual PAA encoding is used, then for the second PAA encoded group set the
Input Source to the first embedded pair relevant to the second group. This may
be Embedded 4 (SDI) or higher. The remainder of the configuration for the
second group is the same as for the first group (steps 5 and 6).
To Next Page
Loading...
