Figure 3.74 VANC Filter Entry Using Wild-cards
3.8 How to Configure the AVP Using the Front Panel
The unit is fully configurable via the front panel. The most important parameters are
available under the dedicated menu items, while the full functionality of an option
card can be found under the Advanced menu. For the details of the interaction with
the front panel and the menu system, see Operation and Control.
The configuration consists setting the general parameters of the base unit and the
option cards. Then, the output streams can be configured through the Output menu.
3.8.1 How to Configure Video Parameters
To configure the video parameters, select the AVP Encoder menu and set the
parameters as listed in Table 3.14.
Table 3.14 Video Parameter Settings
Parameter Setting
Video Input Locked True, False. Read only parameter.
Video Bit rate 0.5 – 80 Mbps. (Limit depends on video profile.)
Video Profile
SD MPEG2 Main Profile Main Level 4:2:0 8 bit
SD MPEG2 4:2:2 Profile Main level 4:2:2 8 bit
SD H.264 Main Profile Level 3.0 4:2:0 8 bit
SD H.264 High Profile Level 3.0 4:2:0 8 bit
SD H.264 High Profile Level 3.1 4:2:0 8 bit
SD H.264 Hi422 Profile Level 3.1 4:2:2 8 bit
SD H.264 Hi422 Profile Level 3.1 4:2:2 10 bit
HD MPEG2 Main Profile High Level 4:2:0 8 bit
HD MPEG2 4:2:2 Profile High level 4:2:2 8 bit
HD H.264 Main Profile Level 4.0 4:2:0 8 bit
HD H.264 High Profile Level 4.0 4:2:0 8 bit
HD H.264 High Profile Level 4.1 4:2:0 8 bit
HD H.264 Hi422 Profile Level 4.1 4:2:2 8 bit
HD H.264 Hi422 Profile Level 4.1 4:2:2 10 bit (The availability of a profile depends on the option card
and the presence of an appropriate license.)
Buffer Mode CBR, Seamless, Fast Channel Zap, Capped VBR.
Source
SDI, Daughter Card
1
, Color Bars, Black, Moving Object, Slate. The input source, which can be an
external video signal through the SDI connector, a Transport Stream to be decoded by the decoder
Daughter Card or an internally generated test pattern.
1
Only available for EI9001T licensed with the AVP/SWO/TRANS.
To Next Page
Loading...
