4. Select Outputs > Service – n and set the PCR PID to the same value as that
set for the component.
Figure 3.16 Service Configuration Web Page – Setting PCR PID
3.7.10 How to Set Up Transcoded (Re-encoded) Services on EI9001T
The AVP fitted with an EI9001T and licensed with the AVP/SWO/TRANS supports
the transcode of services presented on the IP input.
To configure a transcoded service on an AVP, follow the steps below. Here, the IP
output is taken as example. Transport Streams also can be easily configured on
other outputs using the same procedure.
1. Navigate to the Service Configuration web page.
2. Expand the Host Outputs node in the Outputs widget, and click on the required
output. A blue box is drawn around the selected item and the properties
associated with it are displayed in the Transport Stream accordion panel of the
Properties widget.
3. Create a Transport Stream by right clicking on the required output and selecting
the Add Transport Stream command from the context menu, as shown in
Figure 3.17. The properties of the newly created Transport Stream appear in the
Properties widget.
To Next Page
Loading...
