3.7.4 How to Configure Advanced Video Processor Settings
General Advanced Video Processor Settings
To configure the General Advanced Video Processor Settings:
1. Navigate to the Device Configuration page and click on the Advanced Setup
tab.
Note: The Advanced Video Processor Settings widget displays all the unit
parameters organized into different folders in a tree view. The folders can
be expanded and collapsed by clicking on the plus or minus sign next to
them or by selecting a node, right clicking on it, then choosing Expand
Selected or Collapse Selected from the context menu.
2. General parameters such as Unit Name, UTC and SNTP Server are configured
by navigating to Encoder > Base Unit
3. Configure the IP output parameters by navigating to Encoder > Network
Configuration > Data Interface Group 3-4.
Note: There is no actual output until a Transport Stream is created and its Status
of Service parameter is set to Online.
4. Optionally, the redundancy mode for the unit can be set up in the Encoder >
How to Configure Output Transport Streams.
3.7.5 How to Configure Output Transport Streams
To configure a Transport Stream for an AVP, follow the steps below. Here, the IP
output is taken as example. Transport Streams also can be easily configured on
other outputs using the same procedure.
1. Navigate to the Service Configuration web page.
2. Expand the Host Outputs node in the Outputs widget, and click on the required
output. A blue box is drawn around the selected item and the properties
associated with it are displayed in the Transport Stream accordion panel of the
Properties widget.
3. Create a Transport Stream by right clicking on the required output and selecting
the Add Transport Stream command from the context menu, as shown in
Figure 3.7. The properties of the newly created Transport Stream appear in the
Properties widget.
To Next Page
Loading...
