Figure 3.7 Service Configuration Web Page – Adding a Transport Stream
4. Adjust the Transport Stream properties as required.
Note: It is good practice to configure a Transport Stream by setting the Bit rate
tracking mode to Maximize Video. In this way, any changes in the
Transport Stream bit rate will be reflected in the video component bit rates.
5. To set up internally generated ATSC tables, see Chapter 5, Web GUI Control.
6. To create a service in the newly created Transport Stream, make sure the
Transport Stream is selected. Right click on it and select Add Service from the
context menu, as shown in Figure 3.8. The properties of the newly created
service shall appear in the Service accordion panel of the Properties widget.
Adjust the service properties as required.
To Next Page
Loading...
