The fade setting does not affect the current image. It will only be used when saving
OSD 5 and OSD 6 files when it will be stored in the file for later use.
E.6.4 Image Validation
The size and position of the image is validated on loading, each time the resolution
is changed and each time the position is changed.
If the image is too large for the resolution then a warning will be displayed and the
resolution will be reset to the previous setting except on file loading.
If the image is off screen due to the changes, then a warning will be displayed and
(unless the image has just been loaded) the changed setting will be reset to the
previous setting.
E.6.5 Saving the OSD File
Select File > Save As from the menu and select the version of OSD file you wish to
save as from the drop down menu.
OSD 6 files contain all the information on the screen in a binary format. This means
that the files will be smaller and take up less space.
Saving is possible at any time, and it is advisable to save the image often while
editing is in progress. You may also save the file in BMP format, but this file will not
contain transparency information.
To Next Page
Loading...
