Figure 5.12 Component Bit Rates per Transport Stream Accordion Panel
5.2.2.3 Checking the Severity of Alarms
To set the severity of any of the current alarms or any alarms raised since power up,
do the following:
1. On the Current or History tab in the Alarm Monitor widget, click on the arrow
next to the alarm whose severity you want to modify.
2. In the Severity drop down list, set the required severity level.
5.2.2.4 Accepting Hardware Configuration Changes
When the persistent store is cleared, the hardware configuration settings are also
deleted. After the unit is rebooted an alarm will be raised to signify that the hardware
configuration has been changed. This is normal and does not indicate any
malfunction. To clear the alarm, do the following:
1. In the Option Slot Summary accordion of the Device Configuration widget,
click on the Accept Hardware Configuration.
2. The respective alarms are cleared.
5.3 Stored Configurations Page
The Stored Configuration page allows saving the current configuration to or
restoring a stored configuration from the unit. To load or save a configuration
through the front panel, select Manage Configuration.
To Next Page
Loading...
