5. By holding down the left mouse button, drag the item over the new folder in the
Configuration Items widget.
6. Add the item to the new folder by releasing the mouse button. The item cannot
be added to the Quick Setup Items node. Any valid drop position is indicated
by the dragging rectangle changing into green.
7. Repeat the process for any additional items you want to add. You can create as
many folders as you wish or you can use any previously created one. The
created folders can be reordered by the drag-and-drop technique used for
adding the item. The added items can also be relocated through drag-and-drop.
To delete a folder or an item, select it then choose Action > Remove Item.
8. When ready, click Save to save the changes. The new items are added to the
Quick Setup menu.
Notes: The list of added items can be exported by selecting Action > Export and
can be imported on another unit by Action > Import
Parameters associated with Transport Stream creation and configuration
cannot be added to the quickset-up items.
3.7.24 How to Configure Aspect Ratio Conversion for the Down-converted SD
and PiP Output when the Incoming Video is HD
3.7.24.1 Introduction
When an HD input is used, both the SD and PiP encoded outputs are created on the
EI9001 option card from the down-conversion process.
Figure 3.45 HD to SD and PiP Down-conversion
3.7.24.2 Manual Control of the Down-conversion Process
To manually configure the aspect ratio down-conversion:
1. Navigate to the Video Component pane and select the ARC tab.
To Next Page
Loading...
