Table 3.18 IP Related Parameters
Parameter Description
TS Packets per IP Packet Specifies how many Transport Stream packets to encapsulate in one IP packet.
IP Encapsulation
Specifies what higher layer to encapsulate in IP packets. UDP and RTP is self explanatory and
means that the Transport Stream is first encapsulated in UDP or RTP packets, then an IP header is
added. If RTP FEC column or RTP FEC Columns and Row is selected one (Column) or two (Column
and Row) RTP streams are output in addition to the RTP streams that carry the Transport Stream.
IP Configuration/Destination 1
Destination IP Address
The destination IP address to use in the IP packet header of the IP packets that carry the Transport
Stream.
Destination UDP Port
The destination UDP port to use in the IP packet header of the IP packets that carry the Transport
Stream.
Source IP Address
The source IP address to use in the IP packet header of the IP packets that carry the Transport
Stream.
Source MAC Address Read only parameter, not yet supported.
Source UDP Port
The source UDP port to use in the IP packet header of the IP packets that carry the Transport
Stream
6. Select the Service List menu in order to add one or more services to the
Transport Stream.
7. Select Add Service. A new service by the name Service Name appears in the
list.
8. Select Service Name.
9. Check that the parameter settings are correct.
Table 3.19 Component and Service Parameters
Parameter Description
Component List Select to manage components in the service. (Next step.)
Service ID Set Service ID
PMT PID A new PMT PID can be assigned to the service.
PCR PID The PID to be used for the PCR.
If PCR on separate PID is enabled, this value must match the PID given to the PCR component in
the output service.
SDT Parameters Service Provider Set service provider name.
Service Name
Set service name. After setting the service name the service will be listed
accordingly.
Service ID A new ID can be assigned to the service.
Service Type Digital TV, Digital Radio, Teletext, Mosaic, Data Broadcast.
10. Select the Component List menu in order to add one or more components to
the service.
11. Select Add Component. A new component identified by its PID appears in the
list.
To Next Page
Loading...
