Ericsson AVP 4000 - Page 152

Front Panel Control
4-12
1/1553-FGC 101 1790 Uen Y
Bit Rate Weighting
Fixed, Minimum, 2-20. The weighting associated to the current
component. A component with Fixed weighting does not respond to
changes in the Transport Stream Bit Rate. If Minimum is set for a
component, it will always use the minimum Bit Rate defined for the
video profile it is encoded with. A value 2-20 determines how much
a component is changed when the Transport Stream Bit Rate is
changed relative to other components with Bit Rate weighting other
than Minimum.
Master TS Information only – master TS for Bit rate tracking
Service ID
The unique identifier of the current service within the current
Transport Stream.
PMT PID PID assigned to the PMT that describes the current service.
PCR PID
The PID of the TS packets that carry the clock reference for the
current service. If the service has a component with the Embedded
PCR parameter set to On, this field contains the PID of that
particular video stream and it is read only.
SDT Parameters
Service Provider
The name of the service provider as appears in the NIT.
Service Name
The name of the service as appears in the NIT.
Service Type
Digital TV, Digital Radio, Teletext, Mosaic, Data Broadcast.
BISS Key Security key for Basic Interoperable Scrambling System (BISS).
NIT Service Parameters
LCN
0 - 1023
Current State The Setmode state of the Transport Stream. Read only parameter.
Change State
Sets the Setmode state of the Transport Stream. The options
available depends on the value set for MGP Mode under
Advanced/System/MGP Support.
Transport Stream Bit Rate The Bit Rate of the Transport Stream.
Reserved Bit Rate The Bit Rate of the ???.
Bit Rate Tracking Mode
Off, Maximise video. Enables or disables Bit Rate tracking for the
current Transport Stream.
Auto Enable
If set to true, it automatically re-enables the Transport Streams
when all the specified error conditions are cleared.
Auto Disable
Never, Audio Lost, Video Lost, Any Upstream CRITICAL Alarm, Any
CRITICAL alarm. Disables the output when the set condition is met.
The Transport Stream can be set to be re-enabled at the Auto
Enable option.
Syntax DVB, ATSC
Program Specific Information
Transport Strea
m ID A new ID can be assigned to the Transport Stream.
PAT
-PMT On, Off
PAT
-PMT Parameters