Parameter Values Description
AS Index Control Don't Care, Use 1, Use 1 + 2
Only available when Splicing Control is set to On VANC
Message Only.
If set to Don’t Care the AVP 4000 will create SCTE 35
output regardless of the source Automation System.
If set to Use 1 the AVP 4000 will create SCTE 35 output
only for incoming SCTE 104 whose AS Index matches the
setting in AS Index 1.
If set to Use 1 + 2 the AVP 4000 will create SCTE 35
output only for incoming SCTE 104 messages whose AS
Index matches either the setting in AS Index 1 or the
setting in AS Index 2.
DPI PID Index Control Don't Care, Use 1, Use 1 + 2
Determines how many values of DPI PID Index are
compared against the incoming SCTE 104 message.
Available only when Splicing Control is set to On VANC
Message Only.
AS Index 1 0 to 255
The AS index used if AS Index Control is set to Use 1 or
Use 1 + 2.
AS Index 2 0 to 255 The AS index used if AS Index Control is set to Use 1 + 2.
DPI PID Index 1 0 to 255
The DPI PID index used if DPI PID Index Control is set to
Use 1 or Use 1 + 2.
DPI PID Index 2 0 to 255
The DPI PID index used if DPI PID Index Control is set to
Use 1 + 2.
SCTE 104 Encode
Input Stream Channel None
Only available if triggering splicing based on contact
closure through a GPI card.
Splicing Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an SCTE 35 stream is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name> menu on the front panel.
Table 5.28 Slicing Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm. For audio stream, this is Fixed
and read only.
5.5.3.1.4 Teletext Stream Configuration
This section describes the parameters for setting up Teletext.
Teletext
This section gives the parameters that have an effect on how Teletext is transmitted.
To Next Page
Loading...
