Parameter Values Description
Broadcaster ID Mode Off, Auto, Default Only, Source Only Gives what to insert as a broadcaster ID.
Default Servicename The default service name to be used.
Broadcaster ID Source No, Input, Default
Indicates if the Broadcaster ID is derived from the input,
the default or is invalid.
Broadcaster ID
The Broadcaster ID that is currently being inserted into
the output stream.
Generic ANC
Generic ANC Extraction Off, On
Controls whether Generic ANC is extracted from the SDI
stream or not as per SMPTE 2038-2008.
Max ANC Bit Rate 100 to 2000 kbps The maximum data rate of the Generic ANC data output.
Field 1
VBI Line 9 - VBI Line 22
Off, VITC, Closed Captions, Monochrome
Samples
Specifies the content in the respective VBI lines. Set to
Off if the line in the incoming video does not carry any
information, Closed Caption for closed caption
information. Visible for 480i (525-line) input streams.
VBI Line 6 - VBI Line 22
Off, VITS, WSS, WSS-AFD, Teletext
System B, Monochrome Samples
Specifies the content in the respective VBI lines. Set to
Off if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signaling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext. Visible for 576i (625-line)
input streams.
VBI Line 23 Off, WSS, WSS-AFD
Specifies the content of VBI line 23 for 576i (625 line)
input streams.
Field 2
VBI Line 272 - VBI Line 285
Off, VITC, Closed Captions, Monochrome
Samples
Specifies the content in the respective VBI lines. Set to
Off if the line in the incoming video does not carry any
information, Closed Caption for closed caption
information. Visible for 480i (525-line) input streams.
VBI Line 318 - VBI Line 335
Off, VITS, WSS, WSS-AFD, Teletext
System B, Monochrome Samples
Specifies the content in the respective VBI lines. Set to
Off if the line in the incoming video does not carry any
information, VITC for Time Code, WSS for Wide Screen
Signaling, WSS-AFD for Active Format Detection and
Teletext System B for Teletext.
VBI Line Control Manual; RX8
If transcoding IP input, the RX8 decoder can determine
VBI types on VBI lines automatically. It is also possible to
set this manually.
ANC Component
This section describes the parameters associated with the component carrying
ancillary data.
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an ANC stream is selected in the
Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name> menu on the front panel.
To Next Page
Loading...
