Ratio. Bar Data is only SMPTE 2016. This setting is not
available (not visible) when Super Low Delay Buffer Mode
is selected.
TC Output Location Off, SEI Message
Defines how timecode is put into the output video stream.
This setting is not available (not visible) when Super Low
Delay Buffer Mode is selected.
Closed Captions Off, ATSC (default)
Controls if Closed Captions are included in the output
stream. This setting is not available (not visible) when
Super Low Delay Buffer Mode is selected.
Video Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when a video component is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/Slot <x> Video Stream on PID <y> menu on the front
panel.
Table 5.38 Video Component Parameters
Parameter Values Description
PID 16 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed, Minimum, 2 to 20
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm.
Master TS Off, On Sets the master Transport Stream for the component.
Source PID Monitoring None, Monitor, Monitor & Redundancy
Priority 1 ETR290 monitoring on this PID from an IP input
can be enabled, and can be set to cause a redundancy
switch to a spare device if in a system controlled by
Ericsson control software. Not supported in this release.
Multichannel Restrictions
The first channel must always be set to encode. If this is set to OFF, then it will not
be possible to encode any video stream. If there are to be mixed frame rates, the
highest frame rate of all channels must be present on channel 1.
• It is not possible to mix 25 Hz and 29.97 Hz on the same card.
• It is not possible to mix 50 Hz and 59.94 Hz on the same card.
GOP Structure
• There is no restriction across the channels. Each channel may have a different
GOP structure.
Bit Rate
• There is no restriction across the channels. Each channel may have a different
bit rate. If two or more channels are in use the bit rate for each channel may not
exceed 30 Mbps.
To Next Page
Loading...
