Ericsson AVP 4000 - Page 248

Web GUI Control
5-64
1/1553-FGC 101 1790 Uen Y
Ch 1 Profile/Level Available Profile/Level for Ch 2-4
HEVC HD Off
HD HEVC Main Profile Level 4.0 High Tier 4:2:0 8 bit,
HD HEVC Main Profile Level 4.1 High Tier 4:2:0 8 bit,
HD HEVC Main Profile Level 4.0 High Tier 4:2:0 10 bit,
HD HEVC Main Profile Level 4.1 High Tier 4:2:0 10 bit,
HD HEVC Main Profile Level 4.0 High Tier 4:2:2 8 bit,
HD HEVC Main Profile Level 4.1 High Tier 4:2:2 8 bit.
HEVC 3G Off
HDp50/59.94 HEVC Main Profile Level 4.1 High Tier 4:2:0 8 bit,
HDp50/59.94 HEVC Main Profile Level 4.1 High Tier 4:2:2 8 bit,
HDp50/59.94 HEVC Main Profile Level 4.1 High Tier 4:2:0 10 bit,
HDp50/59.94 HEVC Main Profile Level 4.1 High Tier 4:2:2 10 bit.
Note: If channel 1 is set to Off, then no channels will be able to encode.
Vertical Blanking Interval / Ancillary Data
The following parameters are available on the VBI tab of the Properties widget on
the Service Configuration page when a video stream is selected in the Outputs
widget. The same parameters can be accessed through the Advanced/CE-
HEVC/Video/Video 1/Input/VBI Extraction menu on the front panel.
Note: These setting are not available (not visible) when Super Low Delay Buffer
Mode is selected.
Table 5.40 Vertical Blanking Interval / Ancillary Data Parameters
Parameter Values Description
Closed Captions
Closed Captions
Source
Off, SMPTE334
The source for Closed Captions data encoded as part of
the Video Stream. Only applicable when frame rate is
29.97 Hz.
Timecode
TC Mode
Off; External, Zero on Loss; External, Freewheel
on Loss; Internal
Controls what mode the Time code (TC) is working in,
either Off, external source or internally generated. Also
sets what happens on loss of external source (zero or
freewheel).
TC External Source
ANC
VITC1, ANC VITC2, ANC LTC
Controls the external source of Time Code. Auto will select
the first source present in order of the drop down list.
TC Dropframes Off, On, Auto
Only displayed when 29.97 Hz family is selected on Input
tab. Auto configures to external source, or to ON for
internal source.
Table 5.41 ARC Parameters
Parameter Values Description
Aspect Ratio (AR) Signaling
SMPTE2016 Off (Default), On
Controls whether SMPTE 2016 data can be used as a
source for AR info.