5.5.3.2.3 Splicing Stream Configuration
Splicing
The parameters listed in the table below are available on the Splicing tab of the
Properties widget on the Service Configuration page when an SCTE 35 stream is
selected in the Outputs widget. The same parameters can be accessed through the
Advanced/CE-HEVC/Video/Video 1/Video/Main Video/Splicing menu on the front
panel.
Table 5.52 Splicing Parameters
Parameter Values Description
Splicing Control Off, On VANC Message Only
On VANC Message only does not insert splice point, but
converts the SCTE 104 message to SCTE 35 message in
the output.
To enable splicing, a splice point insertion license
(CE/SWO/DPI) is needed.
Splice Null Insertion Off, On
Used to determine the insertion of NULL SCTE 35
messages into the output stream if no messages have
been sent for 500ms.
Audio Splicing Off, On
Used to determine if audio is manipulated at the point that
the video splice occurs.
Splicing Component
The following parameters are available on the Component tab of the Properties
widget on the Service Configuration page when an SCTE 35 stream is selected in
the Outputs widget. The same parameters can be accessed through the
Output/<output name>/Transport Stream ID: <n>/Service List/<service
name>/Component List/<component name> menu on the front panel.
Table 5.53 Slicing Component Parameters
Parameter Values Description
PID 32 to 8190 Sets the packet identifier associated with the component.
Bit Rate Weighting Fixed
Specifies the weight associated to the component in the
Bit Rate Tracking algorithm. For splicing stream, this is
Fixed and read only.
5.5.3.2.4 Teletext Stream Configuration
This section describes the parameters for setting up Teletext.
Teletext
This section describes the parameters that have an effect on how Teletext is
transmitted.
To Next Page
Loading...
