Figure 6.8 Slate Sensitivity Delay Settings
Lock loss generates alarms whether this feature is enabled or not. When it is
enabled, a fail over to slate will suppress further alarms from the next options, even
if these are enabled.
6.6.2.1.2 Option Detect under Action On > Freeze Frame
This feature functions in a similar way to the one above. The condition which starts
the hysteresis is the detection of a still picture. A natural still will not trigger the
condition, only a succession of identical frames. The hysteresis is defined by two
delays “Time Threshold Before Slate” and “Time Threshold Before Recovery”.
Timing is approximate: +/-3 seconds.
To Next Page
Loading...
