Parameter Values Description Comments
Duplex Mode Auto Auto negotiate the mode
Full Duplex Simultaneously transmit and receive
Half Duplex
Transmit and receive in a time
division manner
Default Virtual MAC
Address
aa:bb:cc:dd:ee:ff
The virtual MAC address of the Gex
interface.
Read only parameter
IP Address aaa.bbb.ccc.ddd
IP address of the data interace
group
Subnet Mask 0.0.0.0 [default]
aaa.bbb.ccc.ddd
Subnet mask for the data interface
group
Default Gateway 0.0.0.0 [default] No defined gateway
aaa.bbb.ccc.ddd
Gateway address for packets
outside the defined subnet
IGMP mode selection
IGMP v3 Uses version 3 of the IGMP protocol
IGMP v2 Uses version 2 of the IGMP protocol
Physical Data Interface <n>
Default MAC Address aa:bb:cc:dd:ee:ff
The MAC address of the Gex
interface.
Read only parameter
Link Status Link Up (1000)
Link is up and the link speed is
1000 Mbps.
Read only parameter
Link Up (100)
Link is up and the link speed is
100 Mbps.
Link Down Link is down.
Link Up Time days : hours : mins : secs
The length of time that the link has
been up. If the link goes down this
value is reset to 0.
Read only parameter
TX Packets Number of IP packets transmitted Read only parameter
RX Packets Number of IP packets received Read only parameter
IP Address aaa.bbb.ccc.ddd IP address of the data interface
Data Output
The unit can generate one or more output Transport Streams from the components
produced by the option cards fitted. The IP output Transport Stream packets are
encapsulated in IP packets prior to being transmitted via the Ethernet Data ports.
The base unit does not provide any other interface through which Transport Streams
can be output.
Data Input
The unit has two Ethernet ports for data input, and responds to ARPs, pings and
Reflex PCR exchange messages for statistical multiplexing. The input of data is only
supported for transcoded operation.
To Next Page
Loading...
