12. If one or more DVB subtitle components are selected, in the next screen select
the maximum expected bit rate needed to pass thru the subtitles, as the actual
bit rate used cannot be determined at run time.
Figure 3.27 Transcode Service Configuration – Bit Rate Selection
13. The Transcode Configuration Wizard will prompt you if you want to monitor PIDs
on the incoming source stream. Up to 40 PIDs can be monitored in total across
all services, and can selectively force a switch to a marked backup stream
should a PID be marked for ‘Monitor & Redundancy’.
Figure 3.28 Prompt for Monitor
To Next Page
Loading...
