Showfile Management 75
Showfile Management
This section explains how to create, save, open, delete, import, and export show files. Software upgrades
and creating a default show file are also covered.
Files
All filing operations:
New
Open
Save
Save As
Show files:
Save as default
Remove default
Delete
Import
Export
Media:
Import USB
Import Show
Delete media
Advanced:
Update Firmware
Install Extras
Export Logs
Caution: All data is stored internally in non-volatile memory. Do not switch off the power until
any pending save operation is completed, or you may lose data. It is strongly advised that you
make periodic backups of important data to an external memory stick using the Export function.
File, New
Start a new show by going to Setup>Files>New.
Note: You will be warned that this action will clear the memory. Select Yes to clear memory
and start a new show, or No to cancel.
The new show will be based on the template default show, which is customizable.
File, Open
Open an existing show file by going to Setup>Files>Open.
Note: Show files must be in the console's internal storage before they can be opened here. If
the file is located on a memory stick, you will need to use import first.
To Next Page
Loading...
