G.8032 Configuration Procedure
HMG-838PT & HMG-838EPT Web Configuration A-23
10 f/sec switching time is around 350ms
1 f/sec switching time is around 250ms ~ 3.5s
These settings must be made for each switch and for each (Instance) MEP ID. Care must be taken if performing this
configuration remotely since changing the CCM on one side of an RPL will block that link until both sides of the RPL
have equal CCM frame rate settings. If management for that remote unit depends on the link, be sure to change the
remote end of RPL first then change the local end, at which point the RPL will again be unblocked and the remote
device will be manageable.
To Next Page
Loading...
Need help?
General
