Security
HMG-838PT & HMG-838EPT Web Configuration 5-44
VLAN ID: Specify ARP Inspection is enabled on which VLANs. First, you have to enable the port setting on Port
mode configuration web page. Only when both Global Mode and Port Mode on a given port are enabled, ARP
Inspection is enabled on this given port. Second, you can specify which VLAN will be inspected on VLAN mode
configuration web page. The log type also can be configured on per VLAN setting.
Log Type: There are four log types available.
None: Log nothing.
Deny: Log denied entries.
Permit: Log permitted entries.
All: Log all entries.
5-2.6.3 Static Table
Static ARP Inspection Table:
Port: Select a port to which a static entry is bound.
VLAN ID: Specify a configured VLAN ID.
MAC Address: Specify an allowed source MAC address in ARP request packets.
IP Address: Specify an allowed source IP address in ARP request packets.
Click the “Add New Entry” button to insert an entry to the table.
Select the “Delete” checkbox to remove the entry during the next save.
Click the “Save” button to save newly-configured settings or changes.
Click the “Reset” button to restore settings to default settings or previously configured settings.
5-2.6.4 Dynamic Table Status
Dynamic ARP Inspection Table:
Port: The port number of this entry.
VLAN ID: VLAN ID in which the ARP traffic is permitted.
MAC Address: User MAC address of this entry.
5-3 RADIUS
To Next Page
Loading...
Need help?
General
