Redundancy
HMG-838PT & HMG-838EPT Web Configuration 7-16
MEP Configuration – Instance Data:
Display the details of the current instance item.
MEP Configuration – Instance Configuration:
Level: Select a MEP level. The allowed range is 0~7.
Format: Two formats are available.
ITU ICC: This is defined by ITU in Y.1731 ANNEX A. “Domain Name” is not used. MEG id must be maximum
13 characters.
IEEE String: This is defined by IEEE in 802.1ag. “Domain Name” can be maximum 16 characters. “MEG ID”
(Short MA Name) can be maximum 16 characters.
ITU CC ICC: This is defined by ITU in Y.1731. “Domain Name” is not used. MEG id must be maximum 15
characters.
ICC/Domain Name: Depending on the format selected, enter ITU ICC or IEEE Maintenance Domain Name.
MEG id: This is either ITU UMC (MEG ID value [7-13]) or IEEE Short MA Name depending on “Format”.
MEP id: This value will become the transmitted two byte CCM MEP ID.
Tagged VID: This C-port tag is added to the OAM PDU and is only applicable to port MEP.
MEP STATE
cLevel: Fault Cause indicating that a CCM is received with a lower level than the configured for this MEP.
cMEG: Fault Cause indicating that a CCM is received with a MEG ID different from configured for this MEP.
cMEP: Fault Cause indicating that a CCM is received with a MEP ID different from all 'Peer MEP ID' configured for
this MEP.
cAIS: Fault Cause indicating that AIS PDU is received.
cLCK: Fault Cause indicating that LCK PDU is received.
cSSF: Fault Cause indicating that server layer is indicating Signal Fail.
aBLK: The consequent action of blocking service frames in this flow is active.
aTSF: The consequent action of indicating Trail Signal Fail to-wards protection is active.