EUCHNER MSC - Abbreviations and Symbols; Applicable Standards

9
2121331-04-04/19 (Translation of the original operating instructions)
Operating Instructions
Modular Safety Control System MSC
EN
2.3. Abbreviations and symbols
Abbreviations and symbols
M-A1 Memory card for MSC-CB (accessory)
MSCB Proprietary bus for extension modules
EUCHNER
Safety Designer (SWSD)
MSC configuration software for Windows
OSSD Output Signal Switching Device
MTTF
D
Mean Time to Dangerous Failure
PL Performance Level (according to EN ISO 13849-1)
PFH
D
Probability of Dangerous Failure per Hour
SIL Safety Integrity Level (according to EN 61508)
SILCL Safety Integrity Level Claim Limit (according to EN 62061)
SW Software
2.4. Applicable standards
MSC complies with the following European directives:
Ì 2006/42/EC "Machinery Directive"
Ì 2014/30/EU "EMC Directive"
Ì 2006/95/EC "Low Voltage Directive"
and corresponds to the following standards:
EN IEC 61131-2 Programmable controllers – Part 2: Equipment requirements and tests
EN ISO 13489-1 Safety of machinery. Safety related parts of control systems. General principles for design
EN IEC 61496-1 Safety of machinery. Electro-sensitive protective equipment. Part 1: General requirements and tests.
EN IEC 61508-1
Functional safety of electrical/electronic/programmable electronic safety-related systems: General requirements.
EN IEC 61508-2
Functional safety of electrical/electronic/programmable electronic safety-related systems: Requirements for electrical/electronic/programma-
ble electronic safety-related systems.
EN IEC 61508-3 Functional safety of electrical/electronic/programmable electronic safety-related systems: Software requirements
EN IEC 61784-3 Industrial communication networks: Functional safety fieldbuses
EN IEC 62061 Safety of machinery. Functional safety of safety-related electrical, electronic and programmable electronic control systems
Table 1: Applicable standards