CP-2116E
Remote Control Panel
Revision 1.2 Page - 13
4.4. TESTING THE PANEL’S FUNCTIONALITY
The Test screen enables the user to test the functionality of the LCD touch-screen and LCD buttons.
Once the Test screen is displayed there are four main test options: Key Test, LCD Test,
Touchscreen Test, and GPIO Test.
The user can select a test option using the touch-screen OR the designated soft-
key buttons.
4.4.1. Key Test
Selecting the Key Test option enables the user to test the functionality of the 16 LCD buttons. After
selecting the Key Test option, buttons L1 to L16 will cycle through the following pattern of colours:
RED -> GREEN -> BLUE -> WHITE -> BLACK.
Following this, you will enter a test mode where buttons L1 through L16 display two numerical values
(one on top of the other).
When an LCD button is operating correctly, you may push that button and it will sequence through
different colours each time the button is pushed (RED -> GREEN -> BLUE -> WHITE -> YELLOW ->
TURQUOISE -> PINK -> BLACK). Simultaneously, each time the button is pushed the two numerical
numbers displayed in the button should increment as well.
To exit the Key Test screen, simultaneously hold down the first and last shaft encoders (S1 and S4)
until the Test setup screen is displayed.
4.4.2. LCD Test
Selecting the LCD Test option enables the user to test the LCD monitor. To perform a LCD test select
the LCD Test option. The LCD screen will cycle through a variety of solid coloured and gradient
screens. The screen will continue to cycle until the LCD Test is exited.
To exit the LCD Test, press any of the rotary encoders. This will return the user to the Test setup
screen.
4.4.3. Touchscreen Test
Selecting the Touchscreen Test option enables the user to test the functionality of the LCD touch-
screen. A series of white dots will appear where the user touches the screen in order to show the
screen’s interactivity. Select the Reset Test soft-key (L15) button to clear the white dots. The EXIT
Test soft-key (L13) button will return the user to the Test setup screen.
4.4.4. GPIO Test
Selecting the GPIO Test option enables the user to test GPIs 1-7 and GPOs 1-7. To test the GPOs,
press a GPO soft-key button and the corresponding GPI will become highlighted in green. To test the
GPIs, activate a GPI and observe the corresponding GPI indicator. To exit the GPIO Test screen,
press any of the rotary encoders. This will return the user to the Test setup screen.
To Next Page
Loading...
