CP-2116E
Remote Control Panel
Page - 34 Revision 1.2
3. Enter the PRECISE “short name” of the router device to map to in the Device Name field.
4. Enter the port number (the numerical input) to map to in the Port field.
5. Enter an Alias name for the router source. Please note that this parameter is optional. An
Alias will be used if a device name and port are not provided. The alias would be Global name
of the source as defined in the EQX Server.
6. Enter the name of the desired SNMP service in the Service Name field.
7. Once selected, click the Save button.
8. When you are finished mapping the SNMP Services, be sure to click the “Restart Panel
Software” link found at the top of each page.
5.4.2. Destination Proc Page
The Destination Proc page enables the user to attach an SNMP service to a router’s output port.
Figure 5-23: Destination Proc Page
To create a new Destination-Service Mapping, please follow the numbered instructions in section
5.4.1
To Next Page
Loading...
