CP-2116E
Remote Control Panel
Page - 24 Revision 1.2
2. Assign a new name to the template by entering a name into the Name field.
3. Assign a name for the designated LCD button using the Button Text field.
4. Select a product using the Product drop-down menu. Once the desired product is selected, the
parameter tree will reflect the available parameter items for the selected product. More products
can be added to this list by uploading product jar files using the Products menu under the
Systems menu.
5. Enable or disable Bindings using the Bindings drop-down menu. Please refer to section
5.2.2.1 for more information.
6. Drag and drop a card parameter from the parameter tree to the template parameter list in the
middle of the screen. Please refer to Figure 5-10.
Figure 5-10: Assigning a Parameter
7. For each parameter that is added, the user can fill in the seven properties (i.e. Parameter,
Button Text, Default, Inc, etc). Please refer to section 5.2.2.3 for more information.
8. Click the SAVE button on the right hand side of the screen to save the template.
Please note that the user must press the “Save” button in order for changes to
be saved and then select “Restart Panel Software” to apply the changes to the
control panel.
5.2.2.5. Service Template Controls
To modify the template, use the Service Templates controls. Please refer to section 5.2.2.1 for more
information.
To Next Page
Loading...
