www.cafection.com 800-561-6162
64
DS2212NSA Rev. 1 2023-04
SERVICE & INSTALLATION MANUAL - Symbol
7.8.5 Soluble Whipper Assembly
Frequency: weekly or every 200cycles
It is recommended to remove and clean the whipper assembly every week to avoid
product accumulation that could clog the whipping chamber.
1. Remove the tube from the whipping chamber.
2. Lift the soluble chute up.
3. Twist off the whipper base counterclockwise to unlock the whipper chamber.
4. Pull the whipper chamber outward, then remove the whipping disk.
5. Clean all parts and gaskets under hot water. Use a small brush to clean the tubes if
necessary.
6. Air dry completely.
7. Reinstall all parts in reverse order. Make sure the whipper base is on lock position.
8. Order a large beverage of each soluble to ensure that all parts are working properly..
Step 3 Step 4
Cleaning and Sanitizing
Gasket
Whipper Base
V-Ring Gasket
Whipping Disk
Whipping Chamber
Funnel Cover